Powtran PI8600 Series User Manual

Section V Parameter Function Table
64
Section V
27
FWD torque up limit switch 2
Detail read C parameter system C15.
28
FWD torque up limit switch 3
29
REV torque up limit switch 1
Combine REV torque upper limit switch.
Detail read C parameter system C16.
30
REV torque up limit switch 2
31
REV torque up limit switch 3
32
Torque speed switch
Vector control mode, speed control mode
and torque control mode switching.
Disconnected status: Speed Control
Closed Status: torque control
Detail C parameter set C18
33
Fault reset command
Edge-triggered, the fault occurred on the
current failure to confirm or not confirm
34
FWD JOG command
JOG forward running command
35
REV JOG command
JOG reverse running command
36
JOG order (as F35 setting )
JOG running order,the direction as F35
setting direction
37
Acceleration and deceleration
forbid command
Keep current status , prohibit acceleration
and deceleration movement.
38
Motor 1、2 shift
Motor 1、2 change
Invalid status : Motor 1
Valid status : Motor 2
Off-status ：motor 1；
Close status ：motor
2.
39
Free stop
Free stop ：
free stop ，No starting
command 1S later，allow running again.
40
Up command
Up command ,detail A38~A42.
41
Down command
Down command ,detail A38~A42.
42
Auto-run feature programs canceled
Cancel program running function.
43
Automatic procedures to suspend
operation
Program running pause
44
Program running start mode
Program running start mode
45
Program running stop mode
Program running stop mode
46
Pulse count clearance
Edge trigger, frequency inverter pulse
counter O53 clearance
47
Pulse count input
Edge-triggered, set the pulse counter input
terminal
48
Before count loading
Edge-triggered pulse counter counts o5
maximum load o53
49
Upper count loading
Edge trigger,pluse counter O53 loading up
count value O55.

Powtran PI8600 Series Specifications

General

Brand	Powtran
Model	PI8600 Series
Category	Inverter
Language	English