IMPORTANT: Make sure to mark the left and right end of the common frame take-
up roller prior to removal. The roller must be reinstalled with the same left/right ori-
entation.
5. On legacy frame weldments, loosen the tension enough so that the Take-up roller can
be lifted from the cassette roller mount.
6. On common frame take-up rollers, use a 5/16" hex key socket and ratchet to remove
the two Take-up roller tension bolts (2x) and washers (2x). Retain part(s) and/or
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 180
6 Replacement Procedures
Take-up Roller Replacement
To Next Page
Loading...
