Precor Experience 700 Series - Lift Platform Replacement; About; Procedure

Lift Platform Replacement
About
This procedure provides instruction to remove and replace the Lift Platform.
Procedure
Removal Instructions
Review entire procedure before starting.
1. Remove the hood cover, see "Hood Cover Replacement" on page88.
2. Remove the left/right trim landing covers, see "Trim Landing Covers Replacement"
on page91.
3. Remove the left and right trim side covers see "Covers and Panels Replacement" on
page86.
4. Prepare the treadmill for service. This procedure gains access to the lift platform from
the front of the treadmill. However you can alternatively access the lift platform by lay-
ing the treadmill on its side, see Side access.
a. Access the service menu (51765761) and select INCLINE TEST. Use the
incline control to set the incline level to 14.
b. Securely and safely place supports (e.g. car jack stands) under the left and
right front corners of the frame weldment.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 212
6 Replacement Procedures
Lift Platform Replacement