a. Ifthe console does not power up, make sure the external AC
1
/DC
2
power
adapter is plugged in and connected to the console. Also make sure the AC/DC
adapter brick is in good condition.
b. Run the following console System Tests (see System Tests):
l Touchscreen Test
l Touchscreen Calibration
l Backlight Test
l RGB Test
l Numeric Backlight Test
l Numeric Display Test
Note:Keep in mind that if a key on the console keypad does not function, the LPCA
will not receive a user initiated request for action. For failed console key problems,
the machine failure is not caused by a problem with the LPCA or the machine base,
In these types of console failures, no error codes will be triggered and logged.
Verify that there are no current active error codes
Always review the Error Log or CPA Event Log when troubleshooting an issue. The error
logs will contain any triggered error code events and related information. You can then refer
to the Error Code Troubleshooting Guide for information to help resolve the issue. Also,
when calling Precor customer service for assistance, refer to the Error Log or CPA Event
Log for additional information to help the representative resolve the issue.
l Refer to Error Code & CPA Error Log, see "Error Log & CPA Event Log" on page230.
l Refer to Error Code Troubleshooting Guide the for error code descriptions and repair
information.
IMPORTANT: Error code descriptions and troubleshooting information can be found
in the Error Code Troubleshooting Guide, see Error Code Guide Troubleshooting
Guide.
Note:Not all failures trigger an error event code. Many issues are purely mech-
anical in nature and therefore cannot trigger an error event code.
Verify hardware validation diagnostic tests
Perform the equipment Hardware Validation Tests (LED consoles) or System Tests (Touch-
screen consoles) to help isolate the cause of the issue. These tests will help identify failed
system components. Resolve any resulting failures.
1
Alternating Current: electric current which periodically reverses direction between positive
and negative polarity.
2
Direct Current: electrical current that only flows in one direction.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 225
7 Troubleshooting
Basic Troubleshooting Steps
To Next Page
Loading...
Need help?
General