Precor Experience 700 Series - Page 193

4. Use the 5/16" hex key socket and ratchet to alternately hand tighten the running belt
tension adjustment bolts until snug and stop.
5. Tension the running belt to specification and verify alignment and tracking, see "Run-
ning Belt Tension and Tracking Adjustment" on page67.
6. Reinstall the left and right Landing Trim covers, see "Covers and Panels Replace-
ment" on page86 and hood cover, see "Covers and Panels Replacement" on
page86,.
7. Do the Operation Verification tests (see "Operation Verification" on page24) and
return to service.
Legacy Frame with "Common Take-up Roller" Installation
Legacy Frame - "Common Take-up Roller" Installation
Use this procedure to install the common frame take-up roller onto a legacy frame
weldment.
Review entire procedure before starting.
1. Clean the running belt, deck, and Take-up roller.
2. Install the Take-up roller through the running belt:
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 183
6 Replacement Procedures
Take-up Roller Replacement