EasyManuals Logo

Precor Experience 700 Series User Manual

Precor Experience 700 Series
339 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #220 background imageLoading...
Page #220 background image
11. If the MC was loosened or removed, install the MC and secure fasteners, see "Motor
Controller (MC) Replacement" on page123.
Remove blocking and lower treadmill
Note:If you used the side access method, then refer to the "Side lift motor
jackscrew access" procedure to upright the treadmill, see "Side access" on
page82.
12. .Connect the power cord and switch the power ON. Be aware that switching the
power ON will cause the incline platform to move and return to the level "0" position.
WARNING:Keep hands and appendages clear of the lift platform assembly
before switching power ON. Switching power ON will cause the incline platform to
move to the level "0" Home position.
13. Access the service menu (51765761) and select the INCLINE TEST. Increase the
incline level enough to lift the treadmill frame off the supports.
14. Remove the supports and clear any other items that might either block the treadmill
from lowering or may be damaged as it lowers.
15. Lower the incline to level "0".
Operation Verification
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 210
6 Replacement Procedures
Lift Motor Replacement

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Precor Experience 700 Series and is the answer not in the manual?

Precor Experience 700 Series Specifications

General IconGeneral
BrandPrecor
ModelExperience 700 Series
CategoryTreadmill
LanguageEnglish

Related product manuals