Printronix P7010 - Wlan Leap; Leap Username

WLAN LEAP
101
WLAN LEAP
Auth Method
This feature allows the user to select the authentication method used for the
wireless network interface.
• Open (default). Selects open authentication.
• Shared. Selects shared key authentication.
• Kerberos. Selects Kerberos authentication (for use when a Symbol RF
card is installed).
• LEAP. Selects LEAP authentication (for use with a Cisco RF card
installed).
LEAP Username
• LEAP Username (01-15). The first 15 characters of the LEAP user name
(maximum number of characters is 32).
• LEAP Username (16-30). Characters 16 to 30 of the LEAP user name
(maximum number of characters is 32).
• LEAP User (31-32). Characters 31 to 32 of the LEAP user name
(maximum number of characters is 32).
Reset LEAP User
Resets the LEAP user name to an empty string.
LEAP Password
• LEAP Password (01-15). The first 15 characters of the LEAP password
(maximum number of characters is 32).
• LEAP Password (16-30). Characters 16 to 30 of the LEAP password
(maximum number of characters is 32).
• LEAP Password (31-32). Characters 31 to 32 of the LEAP password
(maximum number of characters is 32).
Reset LEAP Password
Resets the LEAP password to an empty string.
WLAN
LEAP
2
(from page 87)
Auth Method
Open*
Shared
Kerberos
1
LEAP
2
* = Factory Default
1
Only if a Symbol radio card is installed.
2
Only if a Cisco radio card is installed.
LEAP
Username
Reset LEAP
User
LEAP Username (01-15)
LEAP Username (16-30)
LEAP Username (31-32)
LEAP
Password
LEAP Password (01-15)
LEAP Password (16-30)
LEAP Password (31-32)
Reset LEAP
Password