Printronix P7010 - Serial Matrix Emulation; Slew Relative

154
Chapter 4 LinePrinter Plus Emulation (With PCL-II)
Upr. Case Select
Controls how the printer handles lowercase characters it receives from the
host computer. When enabled, all characters will be printed in uppercase.
• Disable (default). Prints lowercase characters received from the host
computer as lowercase, and prints uppercase characters received from
the computer as uppercase.
• Enable. Prints lowercase characters received from the host computer as
their corresponding uppercase equivalents; uppercase characters
received from the computer print as uppercase.
Slew Relative
“Slewing” is rapid vertical paper movement. This parameter determines the
number of lines slewed (either 1-15 lines or 1-16 lines) when an EVFU Slew
Relative command is received. The options include:
• 1-15 Lines (default)
• 1-16 Lines
Serial Matrix Emulation
Printer
Protocol
(from page 138)
Control Code
06
Define CR
Code
Auto LF
Overstrike
Define LF
Code
Printer
Select
Alt. Set
80-9F
Character
Set
ESC d
command
8.0 LPI*
10.3 LPI
6.0 LPI
CR = CR*
CR = CR + LF
Enable*
Disable
Enable*
Disable
LF = LF*
LF = CR + LF
Disable*
Enable
Control Code*
Printable
(see page 157) Even dot plot*
Double high
* = Factory Default
Serial
Matrix