Printronix P7010 - Hex Dump Mode; Downloaded Fonts

222
Chapter 4 ADVANCED USER
PTX Setup Option
Selects the Special Function Control Code for the PTX_SETUP command
and functions.
• Setup Parse. Disables or enables the PTX_SETUP command.
• Setup SFCC. Allows you to choose the hex value of the ASCII character
you wish to use as the SFCC for the PTX_SETUP command. Valid hex
values are 01-FF. The default value is hex 21, which corresponds to the
“!” character.
Hex Dump Mode
A hex code printout (or hex dump) translates all incoming data to hexadecimal
equivalents. A hex dump lists each ASCII data character received from the
host computer, together with its corresponding two-digit hexadecimal code.
Hex dumps can be used to troubleshoot some types of printer data reception
problems. The options include:
• Disable (default)
• Enable
Figure 28 on page 253. shows a hex dump sample.
Power-Up State
• Online (default). The printer powers up in the online state.
• Offline. The printer powers up in the offline state.
NOTE: This option is not available in the PCL-II or LG emulation.
Downloaded Fonts
Allows you to download a substitution table to replace any character in the
current character set with a different character in the same font.
• Char Operations. Allows you to delete a character from flash, load a
character from flash, save a character to flash, and delete a character
from RAM.
• Ld Char at Pwrup. Allows you to disable or enable loading a character at
power up.
• Set Operations. Allows you to delete a character set from flash, load a
character set from flash, save a character set to flash, and delete a
character set from RAM.
• Ld Set at PwrUp. Allows you to disable or enable loading a character set
at power up.
NOTE: This option is not available in the PCL-II or LG emulation.