181
Slash 0
This parameter allows you to print the numeral “0” with or without the slash.
This option applies to all character sets except OCR A and OCR B.
• Disable (default). Zero is printed without a slash.
• Enable. Zero is printed with a slash.
Select LPI
This is the number of lines to be printed per inch. For example, at 6 lpi there is
1/6 inch from the top of one print line to the top of the next print line. The
options are:
• 6.0 (default)
• 8.0
• 9.0
• 10.0
Auto Uppercase
This parameter enables the printer to print text in all uppercase when using
the ALPHA command.
• Disable (default). The printer will print text in upper and lowercase.
• Enable. The printer will print text in uppercase only.
Skip Cmd Prefix
This parameter determines if the printer will print any data before a PGL
command is received.
• Enable (default). The printer ignores all data on the current line before an
IGP command.
• Disable. The printer will print all data on the current line before an IGP
command.
Forms Handling
This submenu allows the user to handle the form in the following ways:
• Disable (the default). No effect.
• Auto Eject. Automatically ejects a page at the end of the job to spill out
the last page.
• Auto TOF. Automatically does a form feed (FF) at the end of each form to
the next top of form.
To Next Page
Loading...
