Printronix P7010 - Simple Prot Conv

Simple Prot Conv
105
Simple Prot Conv
The Simple Protocol Converter (SPC) option allows those who use third party
add-on Coax or Twinax protocol converters to produce the same output on a
Line Matrix printer with the Coax/Twinax (CTHI) capability as done using a
non-CT printer with the third party converter interfaces.
The SPC replaces the third party add-on protocol converters attached to older
line matrix printers.
The SPC gives the printer the operational ability to connect to any PC, or
network system supporting parallel or serial interfaces, and to three different
IBM host systems: System 3x, AS/400
®
, and 3270 Mainframes.
The SPC will support the following third party models for Twinax: MODE 219,
MODE IBM, and MODE PROLINE.
The printer emulations supported by the SPC are Twinax 5225 and Coax
3287. The SPC also provides a range of interfaces available in your line
matrix printer: Centronics, Dataproducts, Serial, Coax, and Twinax. Also
supported are Epson, Proprinter, P-Series, Serial Matrix, IGP/VGL, and IGP/
PGL emulations.
The SPC has the ability to handle multiple print jobs concurrently through
Coax/Twinax and Parallel and Serial interfaces. This is accomplished through
the Auto Switching feature (see
page 73). Because of hardware restrictions,
Coax and Twinax cannot be selected together.
For more information, consult the Coax/Twinax Programmer's Reference
Manual
for the Simple Protocol Converter Option.