Printronix P7010 - Page 63

63
Host Interface
The Host Interface menu enables you to select and configure interfaces
between the printer and your host computer.
Device ID
This parameter defines the printer emulation as IPDS, 4234-2 or 5225. After
the emulation has been changed, a POR status is sent to the host. IPDS is
the default.
Save Config
1*
2 - 8
QUICK SETUP
(from page 62)
Power Up
Config
Factory*
1 - 8
Ribbon End
Point
Darker +6
Darker +5
Darker +4
Darker +3
Darker +2
Darker +1
Normal*
Lighter -1
Lighter -2
Lighter -3
Lighter -4
Lighter -5
Lighter -6
Lighter -7
Lighter -8
Lighter -9
Lighter -10
Horiz
Forms
6
Left Mrg 0.00*
(0-198)
Top Mrg 0/6*
(0-198)
Page Length
Rep
7
Inches/Page*
Lines/Page
Max Line
Width
7
13.2 Inches*
13.6 Inches
Form
Width
5
Funct. of CPI
136 Characters*
(1-272)
Vert
Forms
6
Bot. Frm 66/6*
(0-198)
Top Mrg 0/6*
(0-198)
* = Factory Default
1
If installed
2
If VGL is enabled
3
If VGL is selected
4
If LP+ is selected
5
If ANSI is installed
6
If LG is installed
7
If PCL-II is installed
8
If PGL is selected
9
Available for Zero Tear Pedestal printer only
10
If CTHI is installed and Autoswitching or Twinax is selected
11
Available only if ANSI, LG, or PCL is installed
12
Available only if ANSI, LG, and PGL are not installed