Provision ISR IPSeries - IE Remote Surveillance Via LAN & WAN; Via LAN; Via WAN

To Next Page

To Previous Page

AHD DVR User Manual

8.2 IERemoteSurveillanceviaLAN&WAN

InordertoviewtheDVRfromanetworkitmaybeconnectedtoaLAN/WANorinternet.The

networksetupshouldbedoneaccordingly.Pleaseref erto4.6NetworkSetup.



8.2.1ViaLAN

① GototheDVR’ sMainMenuSetupNetworkinterfacetoinputIPaddress,Subnet

Mask,etc.IfusingDHCP,pleaseenableDHCPinboththeDVRandtherouter.

② EnterRecordSetuptosetnetworkvideoparameterslikeresolution,framerateetc.

③ OpenIEonacomputeronthesamenetwork.InputtheIPaddressoftheDVRinIE

addressbarandpressenter.

④ IEwilldownloadActiveXcomponentautomatically.Entertheusernameandpasswordin

thesubsequentwindow



Notice:IfHTTPportisnot80,addtheportnumberafterIPaddress.Forexample,set

HTTPportas82,inputIPaddresslike192.168.0.25:82.Usernameandpasswordhere

arethesamewiththatusedontheDVR.Thedefaultusernameandpasswordisadmin

and123456.



8.2.2ViaWAN

TherearetwowaysfortheDVRtoconnecttointernet.

1.ConnecttheDVRtointe rnetthroughrouterorvirtualserver.

① GototheDVR’sMainMenuSetupNetworkinterfacetoinputIPaddress,SubnetMask,

etc.IfusingDHCP,pleaseenableDHCPinboththeDVRandrouter.

② ForwardIPaddressandportnumberinVirtualServersetupoftherouterorvirtualserver.

Configure the firewall to allow accessing the DVR (If the user has enabled the UPnP

functioninboththeDVRandrouter,hecanskipthisstep).

③ Ifuserswanttoutilizedynamicdomainname,pleaseapplyforadomainnameinaDNS

serversupportedbytheDVRorrouter.ThenaddtotheDVRorrouter.

④ OpenIEbrowser,inputIPaddress,ordynamicdomainnameandenter.IfHTTPportisnot

80,addtheportnumberafterIPaddressordomainname.

⑤ IEwilldownloadActiveXautomatically.Thenawindowpopsupandasksforusername

andpassword.Inputnameandpasswordcorrectly,andentertoview.



Note:IfyoucannotdownloadandinstallActiveX,pleaserefertoFAQQ7.



2.ConnecttheDVRtointe rnetdirectly.

① GototheDVR’sMainMenuSetupNetworkinterfacetoenablePPPoEandtheninput

usernameandpasswordreceivedfromyourISP.Next,click“Apply”.TheDVRwillconnect

totheserverandwouldgiveaconfirmationmessage.

Related product manuals