EASYROLL SOFTWARE CONFIGURATION TOOL
INTRODUCTION
The EasyRoll Software Configuration Tool is a PC based application that provides the means to configure a
ConveyLinx controlled conveyor system. EasyRoll also provides the ability to change ConveyLinx module default
parameters.
Installing EasyRoll and performing the initial Auto Configuration is described
in the previous section
BASIC FEATURES
Some of the basic module parameters that can be modified by EasyRoll are:
• Graphical view of the current state of each digital input and output
• Configure the module to be Transparent to the flow of ZPA ConveyLinx-Ai2 in a network
• Blink &Wink function used to visually locate an ConveyLinx-Ai2 on the conveyor
EasyRoll has the ability to display the status information for any ConveyLinx module on the network’s subnet.
ADVANCED FEATURES
Some of the advanced features available with EasyRoll are:
• Firmware Upgrade utility for one or a group of ConveyLinx modules
• Network Services Discover utility used to find all ConveyLinx modules on a network and manually set their
I.P. addresses.
• Module Connection mapping to logically link two or more separate ConveyLinx networks.
• The ability to Back-Up and Restore the Network Configuration.
• The ability to restore a backup by IP or by Nodes. Restoring by IP’s is useful when you need to duplicate
part or all of a system.
• Access to the Module Auto-Configuration function
• Access to the Module Replacement function
To Next Page
Loading...
Need help?
General
