106
Frequency and Bandwidth
Only change these settings on the ground with good reception between all network entities!
1. The data link handheld, the Skynav/Toughbook, the main body & the batteries are needed.
2. Open QBase and connect the data link handheld to the Skynav/Toughbook.
3. Ensure the connection between the UAV and the Skynav/Toughbook is established.
4. Connect the battery packs. Attach the cover to secure the batteries. The UAV will power automatically.
5. Select the desired bandwidth rst and the select the frequency. Click apply.
6. After the process is nished, check if aircraft and ground modem are connected.
It is good practice to write down the currently selected bandwidth and frequency, in case you need to replace a ground
modem.
The changes are lost after the next power cycle. If you want to make the changes persistent, use the Save button.
Encryption
It is recommended to change encryption settings via the web interface of the Silvus modems.
Network Transmit (TX) Power
QBase manages the transmit power of every network node, if the Autopower checkbox is checked.
In addition, to optimise power usage, aircraft transmit power is kept at 10 dBm before arming, if the Autopower checkbox is
checked.
The network transmit power can be set, using the TX Power slider.
Click the Set Power button to make the new value active.
Changing the TX Power to a lower value might reduce link stability and quality!
Advanced Settings
The table view shows all nodes in the network and allows changing settings for each node individually. Keep in mind to deac-
tivate the Autopower checkbox, if you want individual settings. Changing the values in this view might reduce link stability and
quality!
To Next Page
Loading...