35
Assembly, Disassembly & Charging
6
6.5.3 Data Link Station
Assemble/Disassemble
The data link station is preassembled and ready-to-use. It is not powered by
batteries but needs to be connected to a power socket. It is recommended
to set it up on a smooth surface (e.g. car roof).
1. Position the suction cups of Data Link Station on the smooth surface.
2. Fixate the Data Link Station on the surface.
3. Power the Data Link Station via the power cable.
4. Connect the Data Link Station to the mission computer
(Skynav/Toughbook) via the cable included.
5. Start the QBase software on the Mission computer.
To Next Page
Loading...