Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
Network CLI Commands 117
collisions:0txqueuelen:1000
RXbytes:24372519(23.2MiB)TXbytes:3113468(2.9MiB)
Interrupt:51Baseaddress:0x2080
eth1Linkencap:EthernetHWaddr00:50:56:AB:00:48
UPBROADCASTRUNNINGSLAVEMULTICASTMTU:1500Metric:1
RXpackets:278736errors:150dropped:0overruns:0frame:0
TXpackets:24057errors:0dropped:0overruns:0carrier:0
collisions:0txqueuelen:1000
RXbytes:24375465(23.2MiB)TXbytes:3081755(2.9MiB)
Interrupt:67Baseaddress:0x20c0
loLinkencap:LocalLoopback
inetaddr:127.0.0.1Mask:255.0.0.0
UPLOOPBACKRUNNINGMTU:16436Metric:1
RXpackets:5872300errors:0dropped:0overruns:0frame:0
TXpackets:5872300errors:0dropped:0overruns:0carrier:0
collisions:0txqueuelen:0
RXbytes:564058955(537.9MiB)TXbytes:564058955(537.9
MiB)
10.20.184.0/21devbond0protokernelscopelinksrc10.20.185.92
defaultvia10.20.184.1devbond0src10.20.185.92
0:fromalllookup255
32766:fromalllookupmain
32767:fromalllookupdefault
WARNING:NoReplicationIPconfigured
Commandcompletedsuccessfully.
2 Delete bond0:
[root@rok‐dxi92DXi]#syscli‐‐delnetcfg‐‐devnamebond0
Youhavespecifiedthefollowingdataforcommand"DelNetcfg":
‐‐devname=bond0
Areyousureyouwanttoproceed?[yes|no]>yes
Commandcompletedsuccessfully.
Note: This will not change the output of syscli --show netcfg because
the add and delete netcfg commands only affect the network
configuration files and not the runtime values.
3 Add the eth0 and eth1 interfaces:
[root@rok‐dxi92DXi]#syscli‐‐addnetcfg‐‐devnameeth0:1‐‐ipaddr
10.20.185.92‐‐netmask255.255.248.0‐‐gateway10.20.184.1
Youhavespecifiedthefollowingdataforcommand"AddNetcfg":
‐‐devname=eth0
‐‐ipaddr=10.20.185.92
‐‐netmask=255.255.248.0
To Next Page
Loading...
Need help?
General