Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
118 Network CLI Commands
‐‐gateway=10.20.184.1
Areyousureyouwanttoproceed?[yes|no]>yes
Commandcompletedsuccessfully.
[root@rok‐dxi92DXi]#syscli‐‐addnetcfg‐‐devnameeth1:1‐‐ipaddr
10.20.185.117‐‐netmask255.255.248.0‐‐gateway10.20.184.1
Youhavespecifiedthefollowingdataforcommand"AddNetcfg":
‐‐devname=eth1
‐‐ipaddr=10.20.185.117
‐‐netmask=255.255.248.0
‐‐gateway=10.20.184.1
Areyousureyouwanttoproceed?[yes|no]>yes
Commandcompletedsuccessfully.
4 Reboot the system using the syscli --nodemanage --reboot command:
[root@rok‐dxi92DXi]#syscli‐‐nodemanage‐‐reboot
Youhavespecifiedthefollowingdataforcommand"Nodemanage":
‐‐reboot
Areyousureyouwanttoproceed?[yes|no]>yes
Broadcastmessagefromroot(pts/1)(WedJun809:51:502011):
ThesystemisgoingdownforrebootNOW!
Commandcompletedsuccessfully.
5 After the system comes back up, display the runtime network values using
syscli --show netcfg. They should now reflect the configured network
values. The output should now show eth0 and eth1 as independent
interfaces.
[root@rok‐dxi92DXi]#syscli‐‐shownetcfg
eth0Linkencap:EthernetHWaddr00:50:56:AB:00:48
inetaddr:10.20.185.92Bcast:10.20.191.255
Mask:255.255.248.0
UPBROADCASTRUNNINGMULTICASTMTU:1500Metric:1
RXpackets:373errors:0dropped:0overruns:0frame:0
TXpackets:80errors:0dropped:0overruns:0carrier:0
collisions:0txqueuelen:1000
RXbytes:32420(31.6KiB)TXbytes:9160(8.9KiB)
Interrupt:51Baseaddress:0x2080
eth1Linkencap:EthernetHWaddr00:50:56:AB:00:56
inetaddr:10.20.185.117Bcast:10.20.191.255
Mask:255.255.248.0
UPBROADCASTRUNNINGMULTICASTMTU:1500Metric:1
RXpackets:260errors:0dropped:0overruns:0frame:0
TXpackets:4errors:0dropped:0overruns:0carrier:0
collisions:0txqueuelen:1000
RXbytes:21262(20.7KiB)TXbytes:168(168.0b)
To Next Page
Loading...
