Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 87 of 252
(3) ConnectChk Timer → press the [Select]-key to display the current time value
(second) → rotate the [ENC] knob or use the [▲/▼]-keys to adjust the
desired connect check time → press the [OK]-key to confirm the
modification → ‘Set Ok!’ pops up on the screen and return to the previous
level.
Timer values: Maximum: 255s
Minimum: 0s
Increment 1s
Notes: When the nearest available repeater is searched by Manual Roaming, the
radio will immediately start timing according to the preset dwell time value. If
the available repeater is not confirmed by pressing the [OK]-key within the
preset time, once the timer reaches the preset time, the radio will stop
roaming; or restart roaming to find the next available repeater.
(4) ReChkTimer → press the [Select]-key to display the current time
value(second) → rotate the [ENC] knob or use the [▲/▼]-keys to adjust the
desired recheck time → press the [OK]-key to confirm the modification →
‘Set Ok!’ pops up on the screen and return to the previous level.
Timer values: Maximum: 255s
Minimum: 0s
Increment 1s
Notes: When the available repeaters are searched by Auto roaming or RSSI roaming,
the radio is confirmed to lock at the currently available repeater and the
roaming is paused. Then, the radio will transmit signals at regular intervals
based on the preset Connect ReCheck timer to connect with the current
repeater. If it fails to connect with the currently available repeater in preset
Connect timer of transmission (set on the Connect timer table), the radio will
restart Auto Roaming or RSSI Roaming to search any nearest available
repeater.
(5) ConnectTime → press the [Select]-key to display the current connect time
→ rotate the [ENC] knob or use the [▲/▼]-keys to adjust the desired connect
times → press the [OK]-key to confirm the modification → ‘Set Ok!’ pops up
on the screen and return to the previous level.
Timer values: Maximum: 10s
Minimum: 1s
Increment 1s
Notes: No matter which roaming mode is selected, in searching, each repeater
channel in the scan list will try to connect with nearby available repeaters
based on the preset Connect times. If the pause channel fails to find the
available repeaters within the preset Connect times, it will continue to scan
the next repeater channel from the list till it finds an available one.
To Next Page
Loading...
