RADWAG WTC 2000

- 27 -
15.1. Computer
<5.1.PC> submenu allows you to:
• select port to which the computer is connected,
• enable/disable continuous transmission,
• set frequency of printouts for continuous transmission.
15.1.1. Computer Port
• Enter <5.1.PC / 5.1.1.Prt> submenu.
• Press
key, parameter values are displayed successively one by one:
nonE – none; rS1 – RS232, USbb – USB type B.
• Press
key to confirm, next go to the home screen.
15.1.2. Continuous Transmission
• Enter <5.1.PC / 5.1.2.Cnt> submenu.
• Press
key, parameter values are displayed successively one by one:
nonE
Continuous transmission disabled.
CntA
Continuous transmission in basic unit.
Cntb
Continuous transmission in current/temporary unit.
• Press key to confirm, next go to the home screen.
15.1.3. Printout Interval for Continuous Transmission
Parameter enabling you to set frequency of printout for continuous
transmission. Printout interval is set in seconds with 0.1 [s] accuracy within 0.1
[s] - 3600 [s] range.
Procedure:
• Enter <5.1.PC / 5.1.3.Int> submenu, window for entering interval value is
displayed.
• Press
key to confirm, next go to the home screen.