RADWAG WTC 2000

- 38 -
In the course of parts quantity determination before
confirming the declared quantity value it is necessary to wait
for a stable measurement,
.
22. WORKING MODE – +/- CONTROL
+/- control is a working mode enabling you to enter checkweighing thresholds
values (Min, Max).
22.1. Local Settings
To go to local settings enter <3.3.HiLo> submenu.
3.3.1.Acc
Working mode accessibility
For detailed description read section 19.2.1.
3.3.2.Snn
Save mode
For detailed description read section 19.2.2.
3.3.3.Int
Time interval
For detailed description read section 19.2.3.
3.3.4.Lo
Lo threshold
For detailed description read section 19.2.4.
22.2. Declaring Checkweighing Thresholds
• Enter <HiLo> working mode (+/- control), first, text <SEt Lo> is displayed
for 1 s, next, window for declaring low weighing threshold (Min).
• Enter respective value and press
key to confirm, first, text <SEt Hi>
is displayed for 1 second, next, window for declaring high weighing
threshold (Max).
• Enter respective value and press
key for confirmation, working
mode's home screen is displayed along with declared threshold value,
where:
Min
Load mass lower than low weighing threshold.
Ok
Load mass within weighing thresholds.
Max
Load mass greater than high weighing threshold.
If the entered low threshold value (Min) is greater than high
threshold value (Max), <Err Lo> error is displayed.