RADWAG WTC 2000

- 33 -
19. WORKING MODES – General Information
The scale features the following working modes:
• Weighing,
• Parts counting,
• +/- control,
• Percent weighing %,
• Peak Hold,
• Totalizing.
19.1. Running Working Mode
• Go to home screen, press
key, name of the first available working
mode is displayed.
• Press
key, names of available working modes are displayed
successively one by one.
• Enter selected working mode, to do it press
key.
The weighing device program has been designed to make
the scale run, upon restart, with the latest operated working
mode on.
19.2. Working Modes Local Settings
Each working mode features specific (local) functions which enable adapting
device operation to individual needs. The functions are to be found in local
settings. To go to local settings of each working mode enter <P3.Func>
submenu. Some special functions are available for all working modes, refer to
the table below:
Weighing
Parts
counting
+/- control
Percent
weighing
%
Peak
Hold
Totalizing
Accessibility 3.1.1.Acc 3.2.1.Acc 3.3.1.Acc 3.4.1.Acc 3.5.1.Acc 3.6.1.Acc
Save mode 3.1.2.Snn 3.2.3.Snn 3.3.2.Snn 3.4.3.Snn - 3.6.2.Snn
Time interval 3.1.3.Int 3.2.4.Int 3.3.3.Int 3.4.4.Int - 3.6.3.Int
Lo threshold 3.1.4.Lo 3.2.5.Lo 3.3.4.Lo 3.4.5.Lo 3.5.2.Lo 3.6.4.Lo