Rain Bird LXME2 User Manual

Current Section: Setup 28 Navigation:
•
Consider using short Soak times, particularly if your watering schedule or Water Window is short. Long delay
times could prevent scheduled irrigation from completing prior to the end of the Water Window.
•
The controller is designed to allow additional stations in the irrigation queue to run during the soak time for
Cycle+Soak stations.
Repeat this process to set up Cycle+Soak on other stations, or copy this same programming to other stations
by following the steps below.
4.4.2 Copy Station To Station
Use this time saving feature to copy the Cycle+Soak™ Programming from one station to other
stations.
Cycle
10
Mins
Soak
05
Mins
001 003
to all stations between
Copy
Cycle
10
Mins
Soak
05
Mins
Sta. 001 through Sta. 003
Copied
1 At the Cycle+Soak™ screen, press the “Copy” key.
2 At the Copy screen, use the & buttons to navigate between the number setting
elds. Press the and keys to set the desired starting and ending station numbers.
3 Press the key to copy the Cycle+Soak settings, or press the key to cancel copying.
4 A conrmation screen shows the process is complete.
4.4.3 Station Delay (Advanced Station Settings)
The LXME2 controller can be programmed to include a delay between stations.
For example, if you set a one minute delay, Station 1 will run until nished, followed by a one minute
delay. Then station 2 will run, followed by another one minute delay, and so on.

Rain Bird LXME2 Specifications

General

Brand	Rain Bird
Model	LXME2
Category	Controller
Language	English