Rain Bird LXME2 User Manual

Current Section: Setup 27 Navigation:
4.4 Advanced Station Settings
4.4.1 Cycle + Soak (Advanced Station Settings)
The LXME2 controller Cycle+Soak feature allows water to be applied to stations intermittently.
This can apply to any station and is useful for locations such as hillsides which can be dicult to
irrigate eectively.
Cycle+Soak consists of two settings:
Cycle time: How long a station will run before soaking.
Soak time: How long irrigation is paused before applying another cycle.
For example, a station can be set up to receive 15 minutes of irrigation in three 5 minute cycles, with
two 10 minutes periods of soak time in between waterings.
•
Cycle+Soak™ settings apply to stations no matter which programs they may be used in.
Next
Advanced Station Settings
Cycle & Soak
Inter-Station Delay
SimulStations
Station Sequencing
Module/Station Numbering
Copy
Station Cycle Soak
Minutes
Cycle & Soak
001 :00 :00
1 Turn the controller dial to Setup
2 On the Setup screen to navigate to “Advanced Station Settings”, then press Next .
3 With “Cycle & Soak” selected press Next .
4 Use the
and buttons to set the Station that you wish to apply Cylce + Soak
programming to.
5 Press the button to navigate to Cycle time.
6 Press the
and keys to set the Cycle time (between 1-60 minutes), then press the
button.
•
Press and HOLD the and buttons to accelerate minute settings.
7 Press the and keys to set the Soak time (between 1-60 minutes).
8 To cancel Cycle+Soak on a station, set both Cycle and Soak to 0.

Rain Bird LXME2 Specifications

General

Brand	Rain Bird
Model	LXME2
Category	Controller
Language	English