Current Section: Manual Watering 77
Navigation:
15. MANUAL WATERING
The LXME2 controller allows you to manually start a station, a program, or to open a Normally Closed
Master Valve (NCMV) to provide water to a for manual watering.
15.1.1 Start Station
•
Manual Watering > Start Station will pause currently running programs.
•
Ensure device addresses are present and entered correctly prior to Manual Station or Manual Program
operations.
Next
Start Station
Start Program
MV Water Window
Test All Stations
Run Time - station
Custom:
Program 1:
Program 2:
HH:MM
00:00
01:15
02:30
001
1 Turn the controller dial to Manual Watering
2 At the Manual Watering screen, with “Start Station” selected, press Next .
3 At the Run Time - Station screen, press the and key to select the desired station
(from 1 to 240) to run manually.
4 Press the Arrow keys to set the station Run Time (from 0 hours, 1 minute to 96 hours).
Press the Run key to start irrigation for that station.
•
Press and HOLD keys to accelerate settings.
5 A conrmation screen shoes that irrigation has started.
Repeat this process to manually water other stations
•
Stations will run sequentially in the order in which they were selected.
6 To view the Station while running, turn the controller dial to the AUTO position. Press
the and keys to add or subtract minutes from the run time for the currently running
station. To advance to the Next station in a program, press the Adv key.
To Next Page
Loading...
Need help?
General
