Current Section: Set Start Times 33
Navigation:
5. SET START TIMES
Start times are the time(s) of day that a program begins.
You can assign up to 10 Start Times to a single program. Multiple Start Times allow you to run a
program more than once on each day. For example, if you’re growing new lawn seed, you may want
to water several times a day to keep the seedbed or top dressing damp.
•
Start times apply to the entire program and not just to an individual station.
PGM 02
1st OFF
PGM 02
1st 12 : 00 PM
1 Turn the controller dial to Start Times
2 At the Set Start Times screen, press the or key to select the program you wish to
create Start Times for.
3 Press the and keys to set the hour, then press the key. Press the and keys to
set the minutes.
•
If the desired program is not selected, press the Program Select Button to change it.
4 Press the and keys to navigate between the number setting elds. Press the and
keys to set additional Start Times (1 through 10).
Use the Program Select button and repeat this process to set up additional Watering Start Times for other
programs as desired.
•
Cycle+Soak™ is an alternative method of dividing the total Station Run Time into smaller cycle times. If you
plan to use Cycle+Soak, only a single Watering Start Time is required for each program. See “Cycle+Soak™”
for more details.
To Next Page
Loading...
Need help?
General
