Rain Bird LXME2 - Page 26

Current Section: Setup 26 Navigation:
Setup a Third Party Flow Sensor (Custom)
Next
Type:
FS 01
Flow Sensor Setup
Custom
Next
K Factor:
Offset:
FS 01
Flow Sensor Setup
001.000
+00.000
1 Turn the controller dial to Setup
2 On the SETUP screen, navigate to “Flow Sensors” using the up and down arrows, then
press Next .
3 On the Flow Sensor Setup screen use the & buttons to navigate to “Custom”, then
press Next .
4 Use the arrow buttons to navigate between number settings elds of the K Factor and
Oset and use the and buttons to set the correct value.
•
Please refer to the instructions provided by the manufacturer of your ow sensor for the correct K Factor and
Oset. These numbers must be correct in order to provide accurate ow information.
5 Press Next when the values on screen are set to the correct value.