Operation Quantron E
33
4
Calibration start Request submenu for executing the cali-
bration test.
page 38
Spreading disc
type
Selection list:
S2
S4
S6
S8
S10
S12
Selection using
arrow keys
Confirmation
with Enter key
Drop point L Input of the left-hand drop point: the dis-
play is only for information.
If the left-hand side is changed, the right-
hand side changes to the same value au-
tomatically.
For AXIS 50.1 W: electrical setting of the
drop point
Observe the
operating in-
structions for
the fertiliser
spreader
page 43
Drop point R Input of the right-hand drop point: the dis-
play is only for information.
If the right-hand side is changed, the left-
hand side changes to the same value au-
tomatically.
For AXIS 50.1 W: electrical setting of the
drop point
Telimat border Storing the Telimat settings for border fer-
tilisation.
Only for fertiliser
spreaders with
Telimat sensor.
Telimat quantity Pre-setting the quantity reduction when
boundary fertilising.
PTO shaft 540 rpm
Height setting Input in cm
Freely editable number values
page 76
Name of fertiliser Selected fertiliser from private table. page 44
Manufacturer Entering the manufacturer of the fertiliser. page 44
Composition Percentage content of the chemical com-
position.
page 44
Fertiliser chart Management of fertiliser charts. page 44
Submenu Meaning/Possible values Description
To Next Page
Loading...