Rauch quantron e - Display Config

Operation Quantron E 4
68
4.8.2 Display config.
The display fields in the operating screen of the control unit can be configures as
required. You can assign both display fields with the following values if desired:
 Ground speed
 Flow factor (FF)
 Time
 ha trip
 kg trip
 m trip
 kg rest
 m rest
 ha rest
Figure 4.34:Display config. menu
[1] Display field 1
[2] Display field 2
Select display (example display field 1)
1. Switch from the System / Test menu to the Display config. submenu.
2. Highlight the display field 1 and press the Enter key.
 The possible displays are listed in the display.
3. Highlight the new value that the display field should use. Press the Enter key.
 The Operating Screen is displayed. The new value is input in display
field 1.
4. Press the Menu key to return to the Display config. menu and then press
the ESC key
or
Press the Menu key to return to the Operating Screen.