Alarm messages and possible causes
77
5
5 Alarm messages and possible causes
Various alarm messages can be displayed on the control unitQuantron E display.
5.1 Meaning of alarm messages
No. Message in display Meaning
Possible cause
1 Error in the metering
direction.
The actuator for the metering device cannot
reach the set value to be moved to.
Blockade
No position message
2 Speed or appl. rate to high. Metering slide alarm
The maximum metering opening is
reached.
The set metering volume (+/- amount)
exceeds the maximum metering open-
ing.
3 Flow factor is outside the
limits
.
The flow factor must be in the range 0.40 -
1.90.
The new calculated or entered flow fac-
tor is outside the range.
4 Left hopper empty! The level sensor on the left reports "empty".
Left-hand hopper is empty.
5 Right hopper empty!
The level sensor on the right reports "empty".
Right-hand hopper is empty.
7 Data will be deleted!
Delete = START
Cancel = ESC
Safety alarm, to prevent the unintentional
deletion of data.
8 Minimum spreading quantity
150 kg not achieved. Old
factor valid.
Flow factor calculation not possible.
Operating mode Auto km/h + Stat. kg
is selected.
The appl.rate is too low to calculate the
new flow factor when the remnant is
weighed.
The old flow factor is retained.
9 Min.setting = 10
Max.setting = 3000
Reference to the value range of the appli-
cation rate.
Value entered is not permitted.
To Next Page
Loading...