Rauch quantron e - Machine Tare

Operation Quantron E 4
30
4.2.4 Machine tare
In this menu, set the weighing value for the empty weighing spreader to 0 kg.
When taring the scales ensure that:
 the hopper is empty,
 the fertiliser spreader is at a standstill,
 the PTO shaft is switched off,
 the fertiliser spreader is horizontal and off the ground.
 the tractor is at a standstill
Tare scales:
1. Switch from the Weighing-Tripcounter menu to the Machine Tare menu.
 The Machine tare menu appears on the display.
2. Confirm with the Enter button.
 The weighing value for the empty scales is now set to 0 kg.
3. Press the ESC key to return to the previous menu.
Figure 4.7: Machine tare
NOTICE
The Machine tare menu item can only be requested if the fertiliser spreader
being used is an AXIS W.
When supplying the control unit with the fertiliser spreader AXIS W this machine
model is factory-set.
NOTICE
Tare the scales before each use in order to ensure problem-free calculation of
the remaining fertiliser quantity.