Rauch quantron e - Page 31

Operation Quantron E
29
4
Working with the weighed fertiliser quantity, topping up the hopper:
1. Tare the scales.
See 4.2.4:
Machine tare, page 30.
2. Select the fertiliser type.
See 4.4.6:
Fertiliser chart, page 44.
3. Fill the hopper.
4. Weigh the fertiliser quantity in the hopper.
See 4.2.3:
Weigh quantity, page 27.
5. Start the work. If the hopper is empty, refill it. To do so, repeat steps 2 to 5.
NOTICE
If the hopper is empty and is filled with less than 200 kg of fertiliser, the flow
factor is fixed and flow factor regulation does not take place (4.4.3:
Flow factor,
page 36). Change to operating mode Auto Km/h.
NOTICE
If the hopper is full and if less than 200 kg of fertiliser is added, push the kg
button and Weigh quantity on the control panel at a standstill.