Rauch quantron e - Acknowledging and Clearing Alarms

Alarm messages and possible causes
79
5
5.2 Clear fault / alarm
5.2.1 Acknowledging alarm message:
An alarm message is highlighted in the display and displayed with a warning icon.
Figure 5.1: Alarm message (example: fertiliser settings)
Acknowledging alarm message:
1. Correct the cause of the alarm message.
Observe the operating manual of the fertiliser spreader and section
5.1:
Meaning of alarm messages, page 77.
2. Press the C/100% key.
 The alarm message is cleared.
5.2.2 Resolving problems with the flow factor regulation (only AXIS W):
Under certain conditions, the display of the flow factor can freeze, despite having
carried out the Weigh Quantity function. The following alarm message appears
in the display.
Figure 5.2: Flow factor error message