Operation Quantron E 4
36
4.4.3 Flow factor
The flow factor is within the range of 0.4 to 1.9. The following applies under the
same basic conditions (km/h, working width, kg/ha):
If the flow factor is increased the metering weight is reduced.
If the flow factor is reduced the metering weight is increased.
If you know the flow factor from earlier calibration tests or from the fertiliser chart,
you can input it manually in this menu.
Figure 4.12:Flow factor menu
With the weighing spreader, the calculation of the flow factor is performed
through dynamic weighing. However, the data can also be entered manually.
Input flow factor:
1. Switch from the Fertiliser settings menu to the Flow Factor menu.
The display shows the currently specified flow factor.
2. Input the new value in the input field with the arrow keys:
Arrow up: Value increases.
Arrow down: Value decreases.
Arrow to the left/right: Cursor moves to the left/right.
NOTICE
The calibration menus (page 38
) permit the flow factor to be determined with the
aid of the Quantron E and entered.
NOTICE
The flow factor calculation depends on the operating mode used. For further
information about the flow factor, refer to section 4.5.2:
AUTO / MAN mode,
page 50.
To Next Page
Loading...