Operation Quantron E
37
4
3. Confirm the input by pressing the Enter key.
The new value is saved in the operator panel.
4. Press the ESC key to return to the previous menu
or
Press the Menu key to return to the Operating Screen.
See also 4.5.2:
AUTO / MAN mode, page 50.
Resolving problems with the flow factor regulation (only AXIS W):
Under certain conditions, the display of the flow factor can freeze, despite having
carried out the Weigh quantity function. The following alarm message appears
in the display.
Figure 4.13:Flow factor error message
Resolving the fault:
See 5.2: Clear fault / alarm, page 79
NOTICE
If your fertiliser is not listed in the fertiliser chart, input flow factor 1.00.
In the AUTO km/h operating mode, we strongly recommend that you perform
a calibration to precisely determine the flow factor for this fertiliser.
NOTICE
On AXIS W (Auto km/h + Auto kg), we recommend displaying the flow factor
on the operating screen (see 4.8.2:
Display config., page 68) in order to observe
the flow factor regulation during spreading.
n CAUTION
Possible spreading error
This alarm message can lead to spreading errors which have a
negative impact on the environment.
Immediately stop the spreading process.
To Next Page
Loading...