Operation Quantron E
45
4
7. Confirm the name input with the F4 key (OK).
The name of the fertiliser chart is saved in the operator panel.
The Fertiliser Settings menu is displayed again.
The steps for specifying the other parameters are described in the
section:
Edit fertiliser chart, page 45.
Selecting existing fertiliser chart:
1. Switch from the Fertiliser settings menu to the fertiliser chart menu.
The Fertiliser Chart Private operating screen is displayed.
2. Select the fertiliser chart with the arrow keys and push the Enter Button.
The Fertiliser Settings menu is displayed in the operating screen.
3. Select the desired fertiliser chart in the name field.
You can move up and down the list of existing fertiliser charts with the arrow
keys.
4. Confirm the selection of a fertiliser chart by pressing the Enter key.
The Fertiliser Settings menu is displayed.
Edit fertiliser chart
1. Select the desired fertiliser chart in the fertiliser chart operating screen and
confirm the selection with the Enter key.
The Fertiliser Settings menu is displayed.
2. Process the parameters in the Fertiliser Chart.
See 4.4:
Fertiliser settings, page 32
NOTICE
We recommend naming the fertiliser chart with the fertiliser name to improve the
classification of the fertiliser chart.
NOTICE
A private fertiliser chart is saved during the initial commissioning of the control
unit. The display of existing fertiliser charts shows 1/1 and the name field is
blank (see:
Create new Private Fertiliser Chart, page 44).
To Next Page
Loading...