Operation Quantron E
61
4
Run fast emptying:
1. Use the Function Button to select the desired part width.
The selected part width is shown as a symbol in the display.
2. Press the Start/Stop button.
Fast emptying is started.
3. To stop fast emptying, press the Start/Stop button again.
4. Press the ESC key to return to the main menu.
n CAUTION
Danger of injury caused by automatic adjustment of
the drop point
On the AXIS 50.1 W the alarm move to drop point intervenes.
After actuating the Start/Stop button, the drop point is automati-
cally approached using the electrical setting cylinder to the pre-set
value. This can cause injuries and material damage.
Before actuating the Start/Stop button, ensure that no one
is in the danger area of the machine.
To Next Page
Loading...