Chapter 4
26 Sidekick Pro Installation & Operation Manual
Meter Cal
The meter cal value for the Sidekick Pro injection pump may be found on the label located on the pump motor.
Enter this value as the initial meter cal in the control console.
Note: The meter cal may be adjusted to refine calibration of the chemical injection pump. Refer to the
Calibrate the Injection Pump section on page 32 to check or refine the meter cal.
FIGURE 1. Sidekick Pro Pump Motor Label with Meter Cal
Valve Type and Valve Cal
The initial valve cal value for any injection pump is 123. When controlled via a CANbus connection, the
Sidekick Pro pump should be set up as a “Standard Valve” on the control console to ensure proper control of
the injection pump.
Note: The initial valve cal may be adjusted to refine Sidekick Pro system response for various application
needs. Refer to the specific control console manual for more information.
Rate Cal
Enter the desired rate of injected chemical in ounces per acre [deciliters/hectare].
Verifying Flow Rate Limits
Before beginning to apply product, use the following formula to verify that Sidekick Pro is capable of applying at
the target application rate and speeds:
Be sure that the calculated volume per minute is within operating tolerance of the injection pump installed on
the implement.
Flow Output Range
P/N 063-0173-081
5-200 oz./min.
[1.5-59 dl/min.]
P/N 063-0173-103
1-40 oz./min.
[0.3-11.8 dl/min.]
Volume Minute
Rate Speed Width
5940 60 000
------------------------------------------------------- -
=
To Next Page
Loading...
