CHAPTER
2
Manual No. 016-0171-391 3
C hapter 2
Introduction
System Overview
The Raven Sidekick Pro injection system is designed to provide efficient and accurate application of liquid
chemicals applied from an injection module. Using a separate injection module, or tank, eliminates mixing
chemicals and reduces chemical waste, and simplifies equipment care and maintenance.
Sidekick Pro provides connectivity to a Raven CANbus system to allow an existing Raven CAN control console
to control the rate of the chemical injection system.
After proper installation and calibration of the injection system and Raven controller, including a set target rate
for the carrier and injected chemicals, the operator enables the product control system and the control console
will automatically maintain the flow regardless of vehicle speed or active boom sections.
Performance of the Raven injection system relies upon proper installation and maintenance of the complete
sprayer system. Please review this manual before installing or operating this system to help ensure proper
setup and follow instructions provided for proper care and maintenance of the Raven injection system.
Injection System Components
The Raven injection system consists of:
• Raven CAN based control console and appropriate cabling
• Sidekick Pro injection pump
• In-line mixer
• Cabling required to connect injection system components and existing CANbus
• Check valves
The following Raven CAN control consoles may be used with the injection system
• SCS 4000/5000 Series
• Envizio Pro
• Viper Pro
To Next Page
Loading...
