5
Manual No. 016-0171-391 39
Setting Application Mode and Injection Diagnostics
Injection Diagnostics Display
1. Touch the Tools Menu icon on the Home screen and select the Product Control icon within the System
menu.
2. Touch the “Injection Settings” button to display the Injection Settings screen.
Calibrate Injection Pump
Touch the “Calibrate Injection Pump” button to start the injection pump calibration process.
Note: The injection pump should be primed before starting a pump calibration.
Prime Injection Pump
Touch the “Prime Injection Pump” button to prime the injection pump. The Envizio Pro will stop the pump when
the system detects the pump has been primed.
Injection Diagnostics
Touch the “Injection Diagnostics” button to view diagnostic information for the selected injection pump.
Injection Pressure. These values are the pressure observed during the pressure stroke of the left and right
pump heads.
Intake Suction. These values are currently not used and will display a value of zero.
To Next Page
Loading...
