SmarTrax & QuickTrax Operation Manual
10
SPS Sensor Setup
The following instructions will help you setup your SmarTrax system for
use with a Linear or Rotary Steering Position Sensor.
1. On the Sensor Type screen, press the Left or Right arrow to display
SPS as the sensor type. Press the Down arrow to make your selection.
2. Next, select the machine type. Use the Left or Right arrows to view the
available options. If a pre-programmed tune set is available for your
specific machine, you may select your vehicle tune set. If no tune set
exists for your vehicle, select one of the generic machine type
(Articulated, Front Steered or Track). Press the Down arrow to select
the displayed option and continue to the next screen.
3. Select the Driving Device (Hydraulic or QuickTrax) by pressing the
Left or Right arrow. When finished, press the Down arrow.
To Next Page
Loading...
