Manual #016-0159-956
19
Hydraulic Calibration
Move the machine to an open area. Be sure the machine is running at
working RPM. Drive ahead from 3-6 mph [5-9 km/h] and press the foot
switch. The wheels will turn as the hydraulics automatically calibrate.
To stop calibration turn the steering wheel to activate the steer switch. To
continue calibration, press the right arrow to bring up the caution screen
and then press the foot switch again.
When the hydraulics calibrate, the wheels will turn to the left and then back
to the right several times. A countdown from 10 to 2 will indicate the
progress of the calibration. The first countdown shows the calibration of
the right hydraulics and the second countdown shows the calibration of the
left hydraulics. If the calibration is successful the SmarTrax will return to
the home screen. If it was not successful, some settings may need to be
changed and another calibration will need to be performed. Refer to the
next section for troubleshooting.
To Next Page
Loading...
