SmarTrax & QuickTrax Operation Manual
40
Toggle GPSE Bypass
Press the Right arrow button to change the status of the GPSE to either
‘Active’ or ‘Bypassed.’
Press the Right arrow to select the desired enhancer status. When you are
finished setting the status, press the Down arrow to continue.
TM-1 Tilt
Sensor
Configuration
The TM-1 Tilt Sensor Configuration Menu screen allows you to change or
set configurations for the TM-1 Tilt Sensor (see list below for
configurations you can set).
• Status
• Zero Tilt Angle
• Tilt Filter Speed
Note: Bypass mode disables the enhancer corrections
Note: This menu screen is only available if you are using
the TM-1 Tilt Sensor.
To Next Page
Loading...
