SmarTrax & QuickTrax Operation Manual
24
.
Receiver Output
The output for the Phoenix 300 Receiver should be set at:
• Baud Rate @ 19200
• GGA @ 10 Hz (.1 seconds)
• VTG @ 10 Hz (.1 seconds)
• ZDA @.2 Hz (5 seconds)
Enhancer
Configuration
Enhancer configuration can be done by accessing the ‘GPS Enhancer
Configuration’ menu screen on the SmarTrax controller. You can only
access this menu if the SmarTrax controller detects the GPS Enhancer upon
initial startup. See Chapter 5 to change the settings for the ‘GPS Enhancer
Configuration’ screen.
To Next Page
Loading...
Need help?
General
