SmarTrax & QuickTrax Operation Manual
46
Status Menu
The Status Menu screen allows you to view or set the following system
configurations:
• Troubleshooting Screen
• Delta Time
• Error Log
• GPS Date and Time
• Yaw Rate (if a Yaw Sensor is detected)
• Time vs. Inches Stats
• Average Speeds
Troubleshooting Screen
The Troubleshooting screen displays the current reading from the steering
sensor and pressure switch. The foot switch is active if the letters appear in
all capitals (ex. FOOT SWTCH). The pressure switch is active if the letters
appear in all capitals (ex. STEER SWTCH). If everything is lower-case,
the foot switch and steer switch are both inactive. The correct operation of
the hydraulics can be verified by pressing the left and right buttons to
manually turn the wheels left and right respectively. The number in the
lower right section of the screen shows the current SPS or Yaw reading. If
an SPS is used, this number should change as the wheels turn. If a yaw is
used, the number should change as the wheels turn if the machine is
moving.
To Next Page
Loading...
Need help?
General
