Manual #016-0159-956
53
Cannot pulse left or
right.
1. Check the hose and cable connections.
2. Check the solenoids for proper connection and
voltage (12 VDC).
3. Adjust sequence valve (for closed center).
4. Adjust pressure relief cartridge.
5. Replace the valve.
6. Replace the controller.
When power is on, the
wheel turns by itself.
1. Make sure that the hoses are connected to the
correct ports.
2. Check all electrical cables.
Steer Switch does not
change to capital letters
(STEER SWTCH)
when wheel is turned.
1. Turn the screw on the pressure switch in or out
until the screen changes.
2. Turn the screw on the needle valve in or out and
counterbalance the cartridges until the screen
changes (for open center).
3. Check the wiring and hose connections to make
sure they are correct and tight.
System pulses the
wrong way.
1. Check the solenoid connections and change
them if they are hooked up backwards.
2. Check the hydraulic hose connections and
switch them if they are hooked up backwards.
Wheels do not move
when using the Manual
Steering screen
1. Turn the screw on the flow control out.
2. Check the hydraulic hoses and plumbing.
System does not engage
by pressing the foot
switch.
1. Turn the screw on the pressure switch in.
2. Turn the screw on the needle valve out.
3. Verify that you are engaging the system from the
Home screen.
The system does not
disengage when you
turn the steering wheel.
1. Turn the screw on the pressure switch out.
2. Turn the screw on the pressure switch in.
3. Turn the screw on the needle valve in.
4. Verify that you are engaging the system from the
Home screen.
Wheels turn the wrong
way with the steering
wheel.
1. Switch the left and right hoses at the orbital or
tees.
Valve makes noise or
‘squeaks’ in stand-by
mode.
1. Turn the screw on the pressure relief switch in.
Mechanical Problem Solution
To Next Page
Loading...
