Raymarine e7 - Page 48

5.Cablecoupler.
6.Thermalcamera.
7.Videoconnection.
Importantnotes
•Youcancontrolthethermalcamerausingyourmultifunctional
display.TheJoystickControlUnit(JCU)isoptional,butcanbe
usedinconjunctionwiththemultifunctionaldisplaytocontrolthe
thermalcameraifrequired.
•“Dualpayload”thermalcamerasinclude2independentlenses;1
forthermal(infrared)andvisiblelight,1forthermal(infrared)only.
Ifyouonlyhave1displayyoushouldonlyconnectthevideocable
labelled“VIS/IR”(visiblelight/infrared)tothedisplay.Ifyouhave
2ormoredisplaysyoushouldconnect1cabletoeachdisplay.
•Youcanonlyviewthethermalcameraimageonthemultifunction
displaytowhichthecameraisphysicallyconnected.Ifyouwant
toviewthethermalcameraimageonmorethan1displayyou
mustobtainasuitablethird-partyvideodistributionunit.
•Forfurtherinformationregardingthecamera’sinstallation
(includingconnectionsandmounting),refertotheinstallation
instructionsthataccompanythecamera.
Thermalcameracables
Cablingrequirementsforthermalcameras.
Cameratonetworkswitch
Anetworkpatchcableisrequiredtoconnectthecameratothe
networkswitch.Theconnectionismadebetweenthecamera
cabletailandthenetworkswitchviathecoupler(suppliedwiththe
camera).Networkpatchcablesareavailableinavarietyoflengths.
JoystickControlUnit(JCU)
AnEthernet(withpower)cableisusedtoconnecttheJCU.TheJCU
issuppliedwitha7.62m(25ft)Ethernetcableforthisconnection.If
yourequireadifferentlengthcontactyourdealerforsuitablecables.
PoweroverEthernet(PoE)injectortonetworkswitch
AnetworkpatchcableisrequiredforconnectingthePoEinjector
tothenetworkswitch.Networkpatchcablesareavailableina
varietyoflengths.
Videocables
Contactyourdealerforsuitablecablesandadaptors.
48e7/e7D—Installationinstructions