Set VCR 2 Channel Displays a choice list that lets you select
the channel that the TV tunes to when you press the VCR2oLD
button.
The choices are the same as those listed under Set VCR 1
Channel, above, except that the component is the second VCR
or laserdisc player, and the remot e button being programmed
is VCR2.LD. For example:
Video 2 Input Choose this if your second VCR or laserdisc
player is connected to the Video 2 jacks on the back of the
TV and you want the TV to tune to Video 2 input when
you press the VCR2.LD button. This is a typical setting for
a second VCR or laserdisc player.
Set DSSoCable Channel Displays a choice list that lets you
select the channel that the TV tunes to when you press the
DSS-CABLE button. Usually, DSSoCABLEcan control either a
DSS® receiver connected to the Video 1 input jacks, or a cable
box connected tothe Antenna A jack.
The choices are the same as those listed under Set VCR 1
Channel, above, except that the component is either a DSS®
Receiver or acable box, and the button being programmed is
DSS.CABLE. Here is an example for each:
Video 1 Input Choose this if your DSS® Receiver is
connected to the Video 1 jacks on the back of the TV and
you want the TVto tune to Video 1 input when you press
the DSS-CABLE button. (This is the typical setting for a
DSS® Receiver.)
Ch 3 Antenna A Choose this if your cable box is
connected to the Antenna A jack on the back of the TV
and you want the TVto tune to Channel 3 when you press
the DSS-CABLE button. (This is a typical setting for a
cable box.)
Video 1 Input Source Displays choice list that lets you tell
the TV whether your Video 1 input source is connected with a
regular video cable or both an S-Video cable and a video
cable.
/
Important
If you are using an S-Video
connection, make sure to change
channel.
44
To Next Page
Loading...
