STEP 4 - Fitting Pull Track
• Fit the Universal arm to the drive shaft (spindle)
at full open position.
• Remove the two ends caps and fit the extended
pull track to cover the 1st and 2nd mark.
• Fix to the door, using the #14-10x1” Phillips/Square
Pan Self-Tapping Screws provided in the screw
pack (or fastener of your choice). You may center
the roller track in the door for visual aesthetics if the
door width allows, but ensure the track covers the
open and close marks for correct operation.
• Re-attach the two end caps to hide the screws.
TRACK MAY BE CENTERED
IN DOOR, AS LONG AS
OPEN AND CLOSE MARKS
ARE COVERED
SCREW TRACK INTO DOOR
& RE-ATTACH END CAPS
Make sure Pull track is installed level with the header. This is to ensure the roller stays
inside the track during opening and closing, prolonging the life of the roller.
STEP 5 - Attaching Universal Arm
• Attach the roller shaft to the arm as shown, making sure the set
screw is tightened into the groove on the roller shaft. This will
ensure that the arm and shaft do not dislocate during operation. For
optimal performance, the roller should be in-between the track limits
as indicated.
• Tighten the M6 x 20mm socket cap screw for the male and female
splines to grip correctly.
LONG ROLLER SHAFT
TRACK UPPER LIMIT
ROLLER CENTERED
BETWEEN LIMITS
• Turn switch to Automatic or ON.
• Test and adjust if necessary.
A
A
SECTION A
ROLLER TRACK
CROSS-SECTION
AS SHOWN
TRACK LOWER LIMIT
ROLLER
M4 x 6mm CONEPOINT SET
SCREW MUST BE TIGHTENED
INTO SHAFT GROOVE
TIGHTEN M6 x 20mm
SOCKET CAP SCREW
INTO ARM
SET SCREW DETAIL
Pg. 29
HA8-SP Manual V. 7.0
Record Canada Inc.
Toll Free: 1-877-348-6837
info.ditec.ca@recorddoors.com
www.recorddoors.ca
Record USA Inc.
Toll Free: 1-866-901-4284
info.ditec.us@recorddoors.com
www.recorddoors.com
To Next Page
Loading...
