To Next Page

To Previous Page

RED DSMC OPERATION GUIDE: EPIC/SCARLET

955-0020_V6.0, REV-J | 212

FUJINON T2.9 CABRIO PREMIER PL LENSES

NOTE: The VTR switch on the lens is mapped to Record: Toggle by default. The VTR switch can be mapped to

another key.

The following Fujinon

T2.9 Cabrio Premier PL lenses are compatible with all DSMC PL mounts, but must be

powered externally and configured a specific way:

 Fujinon 14-35mm T2.9 Cabrio Premier PL

 Fujinon 19-90mm T2.9 Cabrio Premier PL

To set up the Fujinon T2.9 Cabrio Premier PL lenses, follow the instructions below. Refer to the manufacturer’s

operation manual for detailed information about setting up and using the lens.

1. Attach the lens to the DSMC PL mount.

2. On the lens, set the Camera Communication switch to On.

3. On the lens, set the LDS, /i Select switch to Off.

4. Connect an external power source to the lens.

5. Go to Menu > Settings > Setup > Lens.

6. Deselect the Enable Power to Lens check box.

NOTE: This option is only available when a DSMC PL mount is attached to the DSMC.

7. The lens should be successfully connected. However, if lens data does not display within 10 seconds, go

to Menu > Settings > Setup > Lens and select Detect Lens.

CANON EF LENSES

This section describes the appropriate method for attaching and detaching Canon

EF lenses. For more

information, refer to the original manufacturer’s instructions. This section also lists lenses supported by the

DSMC Canon EF Mount.

WARNING: ALWAYS protect your equipment, when it is not in use, by replacing lens caps and mount caps.

ATTACH CANON EF LENSES

1. Rotate the secondary locking ring counter-clockwise to disengage.

2. Press the lens release button and rotate the lens cap counter-clockwise to remove the DSMC mount cap.

3. Remove the rear lens cap.

4. Align the red dot on the lens with the red dot on the DSMC Canon Mount and position the lens in the mount.

5. Turn the lens clockwise until it clicks into place.

6. Rotate the secondary locking ring clockwise to engage.

DETACH CANON EF LENSES

1. Rotate the secondary locking ring counter-clockwise to disengage.

2. Press and hold the lens release button. While holding the lens release button, turn the lens counterclockwise

until it stops and remove it from the DSMC mount.

3. Replace the rear lens cap and DSMC mount cap when the lens is not in use.

Other manuals for RED Epic

Questions and Answers:

Need help?

Do you have a question about the RED Epic and is the answer not in the manual?

General